Avaya DEFINITY Server CSI Maintenance Manual page 995

Table of Contents

Advertisement

DID-DS1 (DS1 DID Trunk)
Port Audit and Update Test (#36)
This test sends port level translation data from the switch processor to the DS1
Interface circuit pack to assure that the trunk's translation is correct. Translation
updates include the following data: trunk type (in/out), dial type, timing
parameters, and signaling bits enabled. The port audit operation verifies the
consistency of the current state of the trunk as kept in the DS1 Interface circuit
pack and in the switch software.
Table 187. TEST #36 Port Audit and Update Test
Error
Test
Code
Result
ABORT
1000
ABORT
1006
ABORT
2000
ABORT
2100
ABORT
FAIL
555-233-119
Description/ Recommendation
Internal system error
1. Retry the command at 1-minute intervals a maximum of 5 times.
The port may be busy with a valid call. Issue the display port PCSSpp
command to determine the trunk group/member number of the port. Use
the status trunk command to determine the service state of the port. If the
service state indicates that the port is in use, then the port is unavailable for
certain tests. You must wait until the port is idle before retesting.
1. If the port status is active but the port is not in use (no calls), check the
error log for error type 1025 (see the Error Log table for a description of
this error and required actions). The port may be locked up.
2. If the port status is idle, retry the command at 1-minute intervals a
maximum of 5 times.
The test was aborted because the trunk is out of service.
1. Use the status trunk command to verify that the trunk is out of service.
2. If the trunk is out of service, determine why.
3. If it is OK to put the trunk back in service, issue the release trunk
command to put the trunk back in service, and then retry the test.
Response to the test was not received within the allowable time period.
Could not allocate resources to run this test.
1. Retry the command at 1-minute intervals for a maximum of 5 times.
Test failed due to Internal system error
1. Retry the command at 1-minute intervals a maximum of 5 times.
Continued on next page
Issue 5 October 2002
995

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents