Avaya DEFINITY Server CSI Maintenance Manual page 868

Maintenance Objects
Memory Card Insertion Test (#695)
This test, which is nondestructive, verifies whether a memory card is inserted into
the memory card slot at the Processor circuit pack and also whether the system
can detect its existence.
Table 138. TEST #695 Memory Card Insertion Test
Error Test
Code Result
2012 ABORT
2106
2114
2013 ABORT
2100
none
FAIL
PASS
868
Issue 5 October 2002
Description/ Recommendation
Internal system error
1. Retry the command at 1-minute intervals a maximum of 5 times.
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
No memory card is inserted in the Processor circuit pack, or the inserted
memory card has a bad connection.
1. Insert a memory card into the slot at the Processor circuit pack.
2. If a memory card is already inserted, take the memory card out and
examine the connectors of the memory card and the Processor circuit
pack. Insert the memory card into the slot again.
3. When a memory card is pushed into the slot, make sure that the
memory card is inserted firmly into the slot.
4. Re-enter test card-mem. If the test still fails, replace the memory card
and rerun the command.
5. If the test still fails after you replace the memory card, replace the
Processor circuit pack. Follow the Standard Repair Procedures for a
memory card.
A memory card is inserted into the Processor circuit pack, and the system
can recognize its existence.
Continued on next page
555-233-119