Avaya DEFINITY Server CSI Maintenance Manual page 1393

MEDPROPT (TN802/TN2302 MED PRO DSP PORT)
Port Status Query Test (#1407)
This test is non-destructive
This test queries the Port status.
Table 362. port Status Query Test (#1407)
Error Test
Code Result Description/ Recommendation
1 ABORT This port is Out of service (OOS) due to:
2 ABORT This port has been made maintenance busy
1002 ABORT The system could not allocate timeslots for the test. The system may
be under heavy traffic conditions or it may have timeslots out of
service due to TDM-BUS errors.
2000 ABORT Response to the test was not received in the allowable time period.
2100 ABORT Could not allocate the necessary system resources to run this test.
2500 ABORT Internal system error.
FAIL Unable to get status for this port. Verify that this board has been
administered correctly, and that there are no alarms against this
board.
PASS The board is functioning properly and the port is in-service and
available.
555-233-119
A board level problem, for example no IP address has been
translated for this location.
A DSP hardware problem (See Test (#1380) and Test (#1382).
1. If system has no TDM-BUS errors and is not handling heavy
traffic, retry the command at 1-minute intervals a maximum of 3
times.
2. If system has TDM-BUS errors, clear any errors, and retry the
command at 1-minute intervals a maximum of 3 times.
3. If the command continues to abort, escalate the problem.
1. Retry the command at 1-minute intervals a maximum of 3 times.
1. Retry the command at 1-minute intervals a maximum of 3 times.
1. Retry the command at 1-minute intervals a maximum of 3 times.
Continued on next page
Issue 5 October 2002
1393