Avaya DEFINITY Server CSI Maintenance Manual page 1388

Maintenance Objects
Table 358. MEDPROPT Error Log Entries — Continued
Error Aux
Type Data Associated Test
258(c) ANY DSP Capacity Test
(#1382)
513(d) DSP Capacity Test
(#1382)
515(e) ANY DSP Capacity Query
Test (##1382)
769 Any TDM NIC
Looparound Test
(#1380)
1025(f) Any
1. Run the Short Test Sequence first. If all tests pass, run the Long Test Sequence. Refer to the
appropriate test description and follow the recommended procedures.
Notes:
a. Error Type 1 - For the TN802B only, this error type indicates that less than
three DSPs are out of service (OOS), and no alarm is raised. The Aux Data
field contains the number of DSPs that are Out of Service (OOS).
b. Error Type 18 - the MEDPRO has been busied out by a busyout port
UUCSS command.
1. Release the port (release port UUCSS).
c. Error Type 258 - For the TN802B only, this error type indicates that more
than three, but less than 9 DSPs are out of service (OOS), and a
WARNING alarm is raised. The Aux Data field contains the number of
DSPs that are Out Of Service (OOS).
d. Error Type 513 - For the TN2302 only, the port is out of service (OOS)
because an associated DSP is bad.
e. Error Type 515 - For the TN802B only, this error type indicates that all
DSPs are out of service (OOS), and a MINOR alarm is raised. The Aux
Data field contains the number of DSPs that are Out Of Service (OOS).
f. Error Type 1025 - The port is out of service (OOS) because of a board
level failure. Check for errors/alarms against the board; in particular, ping
problems, IP address inconsistency, or board sanity problems.
1. Verify correct administration.
2. Check cabling and customer network before replacing circuit pack.
1388
Issue 5 October 2002
Alarm On/Off
Level Board
WARNING ON
MINOR ON
MINOR ON
MIN ON
Test to Clear Value
test board UUCCSS l r5
test port UUCCSSpp
test board UUCCSS l r5
test port UUCCSS l r10
Continued on next page