Avaya DEFINITY Server CSI Maintenance Manual page 1080

NPE Connection Audit Test (#50):
The system sends a message to the on-board microprocessor to update the
network connectivity translation for all the Network Processing Elements (NPEs)
on the circuit pack.
Table 223. TEST #50 NPE Connection Audit Test
Error
Code Test Result
None ABORT
2100
1019 ABORT
FAIL
PASS
0 NO BOARD
1080
Issue 5 October 2002
Description/ Recommendation
System resources required for this test are not available.
Test already in progress.
Internal system error
1. Retry the command at 1-minute intervals a maximum of 5 times.
The circuit pack's NPEs have been updated with their translation.
The test could not relate the internal ID to the port (no board).
This could be due to incorrect translations, no board is inserted, an
incorrect board is inserted, or an insane board is inserted.
1. Check to ensure that the board translations are correct. Use the add
ds1 UUCSS command to administer the DS1 interface if it is not
already administered.
2. If board was already administered correctly, check the error log to
determine if the board is hyperactive. If this is the case, the board is
shut down. Reseating the board will re-initialize the board.
3. Issue the busyout board command.
4. Issue the reset board command.
5. Issue the release busy board command.
6. Issue the test board long command.
This should re-establish the linkage between the internal ID and the port.
Continued on next page
555-233-119