Avaya DEFINITY Server CSI Maintenance Manual page 1610

Maintenance Objects
5. Verify the availability of the external SYS-PRNT output device as follows:
Make sure that the SYS-PRNT output device is on-line and
ready-for-service. Check the physical connectivity between the Data
Module and the SYS-PRNT output device or between the EIA port on the
backplane of the switch and the SYS-PRNT output device.
6. Verify that there are less than three active logins to the system. If this
condition exists, a login session must be terminated before the System
Printer Link can be established.
Error Log Entries and Test to Clear Values
Table 464. SYS-PRNT Maintenance Error Log Entries
Error Aux
Type Data
1
0 0
18 (a) 0
257 (b) 1 to 6
513 (c) 0
1. Run the Short Test Sequence first. If all tests pass, run the Long Test Sequence. Refer to the
appropriate test description and follow the recommended procedures.
2. Minor alarms on this MO may be downgraded to Warning alarms based on the value used in the
set options command.
Notes:
a. System Technician has busied out the System Printer Link.
b. A failure was encountered while attempting to set up the System Printer
Link. This attempt could have been initiated by either the Report Scheduler
software or link maintenance [automatic link retry or the as the result of a
Link Retry Test (#215) request]. The Aux Data field contains the following
diagnostic information to aid in the correction of the failure:
1. unavailability of system resources (too many active logins to the
2. no data channels (DATA-CHLs) available on the Network Control
1610
Issue 5 October 2002
NOTE:
It is recommended that the System Printer Link be busied out before
executing maintenance tests over objects which compose the
System Printer Link. If the System Printer Link is busied out, then all
System Printer Link maintenance actions are deactivated.
Associated Test Alarm Level
Any Any
busyout sp-link WARNING
Link Retry Test MINOR/
(#215) WARNING
None MINOR
system).
circuit pack (DATA-BD).
On/Off
Board Test to Clear Value
Any test sp-link
OFF release sp-link
OFF test sp-link l
2
OFF test sp-link