Table 232. TEST #143 Minor Alarm Inquiry Test — Continued
Error
Code
Test Result
FAIL
PASS
0
NO BOARD
1108
Issue 5 October 2002
Description/ Recommendation
The DS1 Interface circuit pack detects a Minor alarm. The DS1 bit error
rate is greater than 1/1,000,000 and less than 1/1000.
1. The performance of DS1 link between DS1 Interface circuit pack and
remote DS1 endpoint is poor. If DS1 Interface circuit pack is TN767,
enter list measurement ds1-log UUCSS command to read the error
seconds measurement.
2. Verify that both endpoints of the DS1 link are administered using the
same signaling mode, framing mode, and line coding.
3. If the DS1 interface circuit pack connects to a T1 facility, call the
vendor of the T1 carrier to diagnose the remote DS1 endpoint. If the
DS1interface circuit pack connects directly to a switch, call the
system technician of the remote switch to diagnose the DS1
endpoint.
4. Check the physical connection of the DS1 pack and of the cable.
5. If this continues to fail, escalate this problem.
No Minor alarm is detected in DS1 Interface circuit pack.
The test could not relate the internal ID to the port (no board).
This could be due to incorrect translations, no board is inserted, an
incorrect board is inserted, or an insane board is inserted.
1. Check to ensure that the board translations are correct. Use the add
ds1 UUCSS command to administer the DS1 interface if it is not
already administered.
2. If board was already administered correctly, check the error log to
determine if the board is hyperactive. If this is the case, the board is
shut down. Reseating the board will re-initialize the board.
3. If the board was found to be correctly inserted in step 1, issue the
busyout board command.
4. Issue the reset board command.
5. Issue the release busy board command.
6. Issue the test board long command.
This should re-establish the link between the internal ID and the port.
Continued on next page
555-233-119
Need help?
Do you have a question about the DEFINITY Server CSI and is the answer not in the manual?