Avaya DEFINITY Server CSI Maintenance Manual page 1006

Table 189. TEST #6 NPE Crosstalk Test — Continued
Error Test
Code Result
0 NO
BOARD
Looparound and Conference Circuit Test (#33)
This test checks the reflective and non-reflective loop around and conference
capabilities of a DID port circuit. The test that uses 404-Hz, 1004-Hz, and
2804-Hz tones is an on-board test only. Each tone is separately transmitted to and
from the port (loop around within the port) and verified.
This test may fail due to noise induced by adjacent electric power lines.
Customers having this problem should resolve it with their local power company.
To temporarily alleviate the alarm caused by the failure of this test, the test may be
disabled from trunk administration Test field. (This also disables the port
diagnostic test.
Table 190. TEST #33 Looparound and Conference Circuit Test
Error Test
Code Result
ABORT
3 ABORT
1006
Issue 5 October 2002
Description/ Recommendation
The test could not relate the internal ID to the port (no board).
1. Check to ensure that the board translations are correct. Translate the
board, if necessary.
2. Issue the busyout board command.
3. Issue the reset board command.
4. Issue the release busy board command.
5. Issue the test board command. This should re-establish the linkage
between the internal ID and the port.
Description/ Recommendation
Could not allocate the necessary system resources to run this test. This
could be due to a failure to seize the port.
1. Retry the command at 1-minute intervals a maximum of 5 times.
System resources required to run this test are not available. The seized
tone detector did not respond. This abort code is usually associated with
tone-clock (TONE-BD, TONE-PT, and TDM-CLK) resources.
1. Clear any tone errors in the error log.
2. Retry the command at 1-minute intervals for a maximum of 5 times.
3. If the test continues to abort, escalate the problem.
Continued on next page
Continued on next page
555-233-119