Etr-Pt (Enhanced Tone Receiver Port); Hardware Error Log Entries; Test To Clear Values - Avaya DEFINITY Server CSI Maintenance Manual

ETR-PT (Enhanced Tone Receiver Port)

ETR-PT (Enhanced Tone Receiver Port)
MO Name (in
Alarm Log)
ETR-PT(a)
ETR-PT
ETR-PT
1. P is the port network number (1 for PPN). C is the carrier designation (A, B, or C). SS
is the number of the slot in which the circuit pack resides (01 to 21).
NOTE:
Replacing the tone/clock circuit pack requires a special procedure which is
described in the documentation for TONE-BD. This section also describes
the LED display for this board.
The TN2182 is a combined Tone Generator/Tone Detector board, providing 8
Enhanced Tone receiver (ETR) ports. Each of these ports provides the functions
previously found individually on DTMR-PTs, GPTD-PTs and CLAS-PTs ports.
Thus, each port on the TN2182 can be used for any tone detection function that
was previously done by TN748, TN420 or TN744 Tone detection boards.
The TN2182 provides mu-law or A-law tone detection capability.
Since the TN2182 also provides Tone/Clock function, the TN2182 circuit pack is
the only Tone board allowable in the CMC.
Hardware Error Log Entries and Test to Clear
Values
Table 261. Enhanced Tone Receiver Port (ETR-PT) Error Log Entries
Error Aux
Type Data
1 any Tone Detector
Audit/Update Test (#43)
18 busyout port
257 (b) 17666 Tone Detection Audit
Update Test (#43)
513 (c) any Tone Detection
Verification Test (#42)
555-233-119
Alarm Initial Command to
Level
MAJOR test port PCSSpp sh
MINOR test port PCSSpp sh
WARNING test port PCSSpp sh
Associated Test
MAJOR/
MINOR (a)
WARNING
MAJOR/
MINOR (a)
MAJOR/
MINOR (a)
1
Run Full Name of MO
Enhanced Tone Receiver Port
Enhanced Tone Receiver Port
Enhanced Tone Receiver Port
Alarm On/Off
Level Board
ON
OFF
ON
ON
Continued on next page
Issue 5 October 2002
Test to Clear Value
test port PCSSpp r 2
release port
PCSSpp
test port PCSSpp r 3
test port PCSSpp r 3
1177