BRI-PORT (ISDN-BRI Port), ABRI-PORT (ASAI
ISDN-BRI Port)
Receive FIFO Overflow Error Counter Test (#625)
This test reads and clears the BRI port's Receive FIFO Overflow error counter
maintained on the BRI-LINE circuit pack. This counter is incremented by the
circuit pack when it detects an overflow of its receive buffers. The test passes if
the value of the counter is 0 (that is, the error is cleared). If the counter is
non-zero, the test fails, and the value of the counter is displayed in the Error Code
field.
This error can occur if signaling frames are being received from the Packet Bus at
a rate sufficient to overflow the receive buffers on the circuit pack for a port OR if a
hardware fault is causing the receive buffers not to be emptied properly by the
circuit pack. This test is useful for verifying the repair of the problem.
Table 117. TEST #625 Receive FIFO Overflow Error Counter Test
Error
Test
Code
Result
2000
ABORT
2012
ABORT
2100
ABORT
value
FAIL
PASS
555-233-119
Description/ Recommendation
Response to the test was not received from the circuit pack within the
allowable time period.
1. If the test aborts repeatedly a maximum of 5 times, reset the circuit
pack with busyout board PCSS and reset board PCSS.
2. If the test aborts again, replace the circuit pack.
Internal system error
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
The BRI-LINE circuit pack is still detecting errors of this type. The Error
Code field contains the value of this counter.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2. If the test continues to fail, run the Long Test Sequence and look at
the Loop Around Tests (#618 and #619). See the repair procedures
for the executed test if it fails. Otherwise, go to the next step.
3. Replace the circuit pack.
The Receive FIFO Overflow error counter was read correctly and has a
value of 0.
Continued on next page
Issue 5 October 2002
817
Need help?
Do you have a question about the DEFINITY Server CSI and is the answer not in the manual?
Questions and answers