Avaya DEFINITY Server CSI Maintenance Manual page 1593

SW-CTL (Switch Control)
Switch Control Reset Test (#93)
This test is destructive.
This test resets the Switch Control and determines if it can successfully go
through its initialization sequence. The test is destructive since there is the
possibility of losing some control messages to or from port circuit packs.
Table 457. TEST #93 Switch Control Reset Test
Error Test
Code Result
2012 ABORT
2013 ABORT
2100
none
2000 or FAIL
None
PASS
555-233-119
Description/ Recommendation
Internal system error
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
The Switch Control could not be successfully reset. If this is a standard
system, the customer probably cannot make or receive calls.
1. This failure could be due to either a Processor circuit pack failure or the
loss of system timing signals. If the Switch Control is alarmed, then
suspect a Processor circuit pack failure. If the Switch Control is not
alarmed, investigate the possible loss of system timing signals. See
"TDM Bus Clock". If many port circuit pack LEDs are lit, suspect a TDM
Bus Clock problem. If only the Processor circuit pack LED is lit, suspect
the Processor circuit pack. If the Processor circuit pack is determined to
be at fault, proceed to Step 2.
2. If calls cannot be made, replace the Processor board.
The Switch Control has initialized correctly. Look at results of the other tests
to see if it is operating correctly.
Continued on next page
Issue 5 October 2002
1593