Avaya DEFINITY Server CSI Maintenance Manual page 838

Maintenance Objects
Table 127. TEST #628 BRI XID — Continued
Error Test
Code Result
1187 ABORT
2012 ABORT
2100 ABORT
2000 FAIL
PASS
838
Issue 5 October 2002
Description/ Recommendation
The circuit pack, port or station may have been busied out by a technician.
1. Look in the Error Log for Error Type 18 (busied out) for BRI-BD,
BRI-PORT, or BRI-SET.
2. If this error type is present for BRI-SET only, release the station with
release station.
a. If this error type is present for BRI-PORT and BRI-SET, release the
port release port PCSSpp and run the test again.
b. If the error is present for BRI-BD, BRI-PORT, and BRI-SET, release
the circuit pack with release port PCSSpp and run the test again.
If the error is present for BRI-SET only, release the circuit pack via
release port PCSSpp and run the test again.
If the error is present for both BRI-BD and BRI-PORT, release the
circuit pack via release board PPCSS and run the test again.
NOTE:
When you release the circuit pack, you release all ports associated
with it. If certain ports still need to be busied out, use release port
PCSSpp to busy them out.
3. Make sure the terminal is connected.
4. Retry the command at 1-minute intervals a maximum of 5 times.
Internal system error
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
The XID-RESPONSE message was not received from the endpoint.
1. Consult the endpoint documentation to determine if the Layer 2 XID
and XID-RESPONSE messages are supported. If the documentation
reflects no support for these messages, use change station
extension and enter n in the
2. If the endpoint supports these Layer 2 messages and the test
continues to fail, assume the endpoint is defective and replace it.
The switch can successfully pass messages over the D-channel to the BRI
endpoint.
XID Testing field.
Continued on next page
555-233-119