Avaya DEFINITY Server CSI Maintenance Manual page 1060

System Technician-Demanded Tests: Descriptions
and Error Codes
Always investigate tests in the order they are presented in the table below when
inspecting errors in the system. By clearing error codes associated with the NPE
Crosstalk Test, for example, you may also clear errors generated from other tests
in the testing sequence.
For example, you may also clear errors generated from other tests in the testing
sequence.
NPE Crosstalk Test (#6)
Dial Tone Test (#0)
Loop Around and Conference Test (#33)
Audit Update Test (#36)
1. D = Destructive; ND = Nondestructive
Dial Tone Test (#0)
This test attempts to seize a port and checks for the return of a dial tone.
Table 216. TEST #0 Dial Tone Test
Error Test
Code Result
ABORT
1000 ABORT
1001 ABORT
1060
Issue 5 October 2002
Order of Investigation
Description/ Recommendation
Could not allocate system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
System resources required to run this test are not available. The port may
be busy with a valid call. Use the command display port PCSSpp to
determine the trunk group/member number of the port. Use the status
trunk command to determine the service state of the port. If the service
state indicates that the port is in use, then the port is unavailable for certain
tests. You must wait until the port is idle before retesting.
1. If the port status is idle, then retry the command at 1-minute intervals a
maximum of 5 times.
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Short Test Long Test
Sequence Sequence
X
X
X
X X
Continued on next page
555-233-119
1
D/ND
ND
ND
ND
ND