Avaya DEFINITY Server CSI Maintenance Manual page 1102

Table 230. TEST #141 Yellow Alarm Inquiry Test
Error
Code Test Result
ABORT
2100 ABORT
2000 ABORT
1102
Issue 5 October 2002
Description/ Recommendation
Internal system error
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Response to the test was not received within the allowable time period.
This may be due to hyperactivity. Error type 1538 in the error log indicates
hyperactivity. The hyperactive circuit pack is out of service and one or
more of the following symptoms may appear.
1. The DS1-BD tests (such as test 138 and test 139) are aborting with
error code 2000.
2. The tests run on the ports of this circuit pack are returning a no board
result.
3. A busyout or a release command has no affect on the test results.
4. A list config command shows that the circuit pack and the ports are
properly installed.
NOTE:
When hyperactivity occurs, the circuit pack is isolated from the
system, and all of the trunks for this circuit pack are placed into the
out of service state. The system will try to restore the circuit pack
within 15 minutes. When no faults are detected for 15 minutes, the
DS1 interface circuit pack is restored to normal operation. All of the
trunks for the DS1 interface circuit pack are then returned to the in
service state. Hyperactivity is often caused by the associated
facility. In such a case, faults (such as slips, misframes, or blue
alarms) would be entered in the error log. In addition, many
hardware errors would be logged against the associated trunk
circuits. If the facility is OK and the error occurs again after 15
minutes, escalate this problem.
Continued on next page
555-233-119