Avaya DEFINITY Server CSI Maintenance Manual page 840

Maintenance Objects
Table 128.
TEST #629 BRI Layer 3 Query
Error Test
Code Result
1187 ABORT The circuit pack, port or station may have been busied out by a technician.
2012 ABORT Internal system error
2100 ABORT Could not allocate the necessary system resources to run this test.
2068 ABORT The endpoint has rejected the switch sent application message. This indicates
that the endpoint does not support the ISDN-BRI Management and
Maintenance Procedure for Endpoint Service Messages.
840
Issue 5 October 2002
— Continued
Description/ Recommendation
1. Look in the Error Log for Error Type 18 (busied out) for BRI-BD,
BRI-PORT, or BRI-SET.
2. If this error type is present for BRI-SET only, release the station with
release station.
a. If this error type is present for BRI-PORT and BRI-SET, release the
port with release port PCSSpp and run the test again.
b. If the error is present for BRI-BD, BRI-PORT, and BRI-SET, release
the circuit pack with release port PCSSpp and run the test again.
If the error is present for BRI-SET only, release the circuit pack with
release port PPCSS and run the test again.
If the error is present for both BRI-BD and BRI-PORT, release the
circuit pack with release board PPCSS and run the test again.
NOTE:
When you release the circuit pack, you release all ports
associated with it. If certain ports still need to be busied out,
use the release port PCSSpp command to busy them out.
3. Make sure the terminal is connected.
4. Retry the command at 1-minute intervals a maximum of 5 times.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1. Use change station extension and set the
n.
field to
MIMs Supported
Continued on next page
555-233-119