CO-DS1 (DS1 CO Trunk)
Table 157. TEST #36 Port Audit and Update Test — Continued
Error
Test
Code
Result
0
NO
BOARD
DS1 CO Dial Tone Seizure Test (#314)
DS1CO Dial Tone Seizure Test checks the trunk's signaling capability provided by
the DS1 Interface circuit pack. The maintenance software initiates the test by
sending a "seizure" message to the DS1 Interface circuit pack and expects an
"active" reply from the DS1 interface circuit pack. If the "active" message is
received, the test passes. If no message is received and the timer expires, the test
is aborted. If the DS1 Interface circuit pack sends a "reorder" message back to
maintenance software, the test fails.
The test CANNOT be run on a trunk if one of the following cases is true:
a. The trunk direction is administered as an incoming only trunk.
b. The trunk has been seized by a normal trunk call.
c. The trunk is administered with maintenance test disabled.
555-233-119
Description/ Recommendation
The test could not relate the internal ID to the port (no board). This result
could be due to incorrect translations, no board is inserted, an incorrect
board is inserted, an insane board is inserted, or the board is hyperactive
(see note below).
1. Check to ensure that the board translations are correct. Use list config
and resolve any problems that are found.
2. If the board was found to be correctly inserted in step 1, issue busyout
board.
3. Issue reset board.
4. Issue release busy board.
5. Issue test board long.
This should re-establish the linkage between the internal ID and the port. If
this is not the case, dispatch to check to ensure that there is a valid board
inserted.
Hyperactivity causes some special problems with the sequence suggested
above. If the ports are translated after issuing list config, but the
field reports that there is no board when there really is a board, busyout
board and release busy board will not work even though the reset board
works. The software puts the hyperactive board back in service after the
hyperactivity clears.
Vintage
Continued on next page
Issue 5 October 2002
909
Need help?
Do you have a question about the DEFINITY Server CSI and is the answer not in the manual?