Avaya DEFINITY Server CSI Maintenance Manual page 1665

TDM-BUS (TDM Bus)
Control Channel Test (#296)
This test tests the integrity of the Control Channel bus. It ensures that
communication through the TDM Bus is operational.
Table 488. TEST #296 Control Channel Test
Error Test
Code Result
any code ABORT
other than
1005
1005 ABORT
none FAIL
PASS
555-233-119
Description/ Recommendation
Internal system error
1. Retry the command at 1-minute intervals a maximum of 5 times.
Since this test is valid only on the control channel bus, it aborts execution
when run on the non-control channel bus. This is a valid response. Use the
status system command to verify which bus is the control channel bus.
Communication through the Control Channel is not working. The problem is
not necessarily the TDM Bus itself.
1. Display the hardware error and alarm log for the Tone-Clock circuit
pack. Refer to TONE-BD (Tone-Clock Circuit Pack) Maintenance
documentation.
2. Resolve the errors for the Tone-Clock circuit pack.
3. Display the hardware error and alarm log for the Network Control circuit
pack. Refer to DATA-BD (Network Control Circuit Pack) Maintenance
documentation.
4. Execute the test tdm P command again.
5. If the test still fails, refer to the
Procedure'' described earlier.
Communication through the TDM Bus is operational.
''TDM Bus Fault Detection and Isolation
Continued on next page
Issue 5 October 2002
1665