Qos Port Default Dscp - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

qos port default dscp

Configures the ToS/DSCP value to be inserted in flows ingressing on an untrusted port.
qos port slot/port default dscp value
Syntax Definitions
slot/port
value
Defaults
parameter
value
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
The value configured by this command sets the upper byte (precedence) and therefore configures the
ToS/DSCP value for the port.
•
The default DSCP value is not used if there is a matching QoS policy rule that sets the priority.
•
Note that on the 802.1p bit for tagged packets received on untrusted ports is set with the default 802.1p
value, which is configured using the
however, then the DSCP bit is set with the default DSCP value, which is configured using the qos port
default dscp command.
Examples
-> qos port 3/1 default dscp 63
Release History
Release 6.1; command was introduced.
page 32-58
The slot number and port number of the physical port.
The ToS/DSCP value. The range is 0–63.
default
0
qos port default 802.1p command. If the packet is untagged,
OmniSwitch CLI Reference Guide
QoS Commands
June 2012