Qos Port Default 802.1P - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

qos port default 802.1p

Configures the 802.1p value to be inserted in flows ingressing on an untrusted port.
qos port slot/port default 802.1p value
Syntax Definitions
slot/port
value
Defaults
parameter
value
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
By default untrusted ports will set the 802.1p bit to zero on incoming flows. Use this command to spec-
ify that a different 802.1p value should be applied to the flow.
•
The default 802.1p value is not used if there is a matching QoS policy rule that sets the priority.
•
Note that on the 802.1p bit for tagged packets received on untrusted ports is set with the default 802.1p
value, which is configured using the qos port default 802.1p command. If the packet is untagged,
however, then the DSCP bit is set with the default DSCP value, which is configured using the
default dscp command.
Examples
-> qos port 3/1 default 802.1p 5
Release History
Release 6.1; command was introduced.
Related Commands
qos apply
qos port
show qos port
page 32-56
The slot number and port number of the physical port.
The priority value to be set. Values range from 0 (lowest priority) to 7
(highest priority).
default
0
Applies configured QoS and policy settings to the current configuration.
Configures a physical port for QoS.
Displays information about QoS ports.
OmniSwitch CLI Reference Guide
QoS Commands
qos port
June 2012