Honda Accord 2008 Manual page 1256

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:17:16 61TA0000_160_0017

6. To completely seat the outboard joint, pick up the

driveshaft and joint, and tap or hit them from a

height of about 10 cm (4 in.) onto a hard surface.

NOTE: Do not use a hammer as excessive force

may damage the driveshaft. Be careful not to

damage the threaded section (A) of the outboard

7. Check the alignment of the paint mark (A) you

made with the outboard joint rim (B).

8. Pack the outboard joint (A) with the remaining joint

grease included in the new outboard boot set.

Total grease quantity

Outboard joint:

A/T model: 105 115 g (3.7 4.1 oz)

M/T model: 140 150 g (4.9 5.3 oz)

Use the grease included

in the outboard boot set.

9. Fit the boot ends (A) onto the driveshaft (B) and the

outboard joint (C). Bleed any excess air from the

boot by inserting a flat-tipped screwdriver between

the boot and the joint.

Chapters

Table of Contents