Wheel Bolt Replacement - Honda Accord 2008 Manual

07/11/02 09:27:31 61TA0000_180_0009
4. Reset the dial gauge to the position shown, and
measure the radial runout.
Front and rear wheel radial runout:
Standard:
Service limit: 1.5 mm (0.06 in.)
＊０２
5. If the wheel runout is not within the specification,
check the wheel bearing end play (see page 18-8),
and make sure the mating surfaces on the brake
disc and the inside of the wheel are clean.
6. If the bearing end play is within the specification
but the wheel runout is more than the service limit,
replace the wheel.
Steel wheel: 0 1.0 mm (0 0.04 in.) − −
Aluminum wheel: 0 0.7 mm (0 0.03 in.) −

Wheel Bolt Replacement

Special Tools Required
Ball joint remover, 28 mm 07MAC-SL0A202
• Do not use a hammer or air or electric impact
tools to remove and install the wheel bolts.
− • Be careful not to damage the threads of the
wheel bolts.
Front
1. Remove the front hub (see page 18-17).
2. Separate the wheel bolt (A) from the hub (B) using
a hydraulic press. Support the hub with hydraulic
press attachments (C) or equivalent tools.
NOTE: Before installing the new wheel bolt, clean
the mating surfaces on the bolt and the hub.
B
C
3. Insert the new wheel bolt into the hub while
aligning the splined surfaces on the hub hole with
the wheel bolt.
NOTE:
• Degrease all around the wheel bolt.
• Make sure the wheel bolt is installed vertically in
relation to the hub disc surface.
4. Install the wheel bolt using a hydraulic press until
the wheel bolt shoulder is fully seated.
5. Install the front hub (see page 18-17).
NOTE: If you cannot tighten the wheel nut to the
specified torque value when installing the wheel,
replace the front hub as an assembly.
ＴＡ０８Ａ００Ｂ５４１０００６５２３１ＫＢＡＴ００
Press
A
＊０１
C
(cont'd)
18-9 18-9