Honda Accord 2008 Manual page 1726

07/11/02 09:34:18 61TA0000_200_0159
4. Remove the passenger's dashboard center lower
cover (A).
–1 Remove the clip (B).
–2 Gently pull the front upper edge of the cover to
–3 Pull up the cover to release the hook (D) from
＊０３
Fastener Locations
B
5. Install the cover in the reverse order of removal,
and note these items:
• If the clips are damaged or stress-whitened,
replace them with new ones.
• Push the clips into place securely.
• Make sure the hooks are set properly.
detach the clip (C).
the rear heater duct (E).
: Clip, 1 C : Clip, 1
E
A
Center Display Visor Removal/
Installation
Special Tools Required
KTC trim tool set SOJATP2014
Available through the American Honda Tool and
Equipment Program; call 888-424-6857
Without Navigation System
NOTE:
• Take care not to scratch the dashboard and its related
parts.
• Use the appropriate tool from the KTC trim tool set to
avoid damage when removing components.
1. Remove these items:
C
• Center pocket (see page 20-154)
• Driver's inner dashboard trim (see page 20-153)
• Passenger's dashboard trim (see page 20-159)
• Audio-HVAC module (see page 23-111)
D
2. Remove the center display visor (A).
B
–1 Remove the screws.
–2 Pull out the visor to detach the clips.
Fastener Locations
: Screw, 2
A
3. Install the visor in the reverse order of removal,
and note these items:
• If the clips are damaged, replace them with new
ones.
• Push the clips into place securely.
ＴＡ０８ＡＮ０Ｊ２６２２０２１６４３５ＫＤＡＴ０１
: Clip, 6
20-157 20-157
＊０１