Honda Accord 2008 Manual page 1649

07/11/02 09:31:05 61TA0000_200_0082
Glass
Quarter Glass Replacement (cont'd)
16. Put the cartridge in a caulking gun, and run a bead
of adhesive (A) around the edge of the quarter
glass (B) and along the front seal (C) as shown.
With the printed dots on the quarter glass as a
guide, apply the adhesive to the rear corner, upper
corner and lower corner portions of the quarter
glass. Apply the adhesive within 30 minutes after
applying the glass primer. Make a slightly thicker
bead at each corner.
＊１１
6.5 mm
(0.26 in.)
2 mm
(0.08 in.)
30..5 mm
(1.2 in.)
20-80
2 mm (0.08 in.)
A
13 mm
(0.51 in.)
8 mm (0.31 in.)
A
B
A
B
A
24 mm
A
11 mm (0.94 in.)
(0.43 in.)
B
A
B
17. Use suction cups (A) to hold the quarter glass (B)
over the opening, align it with the clips (C), and set
it down on the adhesive. Lightly push on the
quarter glass until its edges are fully seated on the
adhesive all the way around.
NOTE: Do not open or close any of the doors for
about an hour until the adhesive is dry.
B
2 mm
(0.08 in.)
C
18. Scrape or wipe the excess adhesive off with a putty
knife or towel. To remove adhesive from a painted
surface or the quarter glass, use a soft shop towel
dampened with isopropyl alcohol.
19. After the adhesive has dried, spray water over the
quarter glass and check for leaks. Mark the leaking
areas, let the quarter glass dry, then seal with
sealant. Let the vehicle stand for at least 4 hours
after quarter glass installation. If the vehicle has to
be used within the first 4 hours, it must be driven
slowly.
20. Reinstall all remaining removed parts.
NOTE: Advise the customer not to do the following
things for 2 to 3 days:
• Slam the doors with all the windows rolled up.
• Twist the body excessively (such as when going
in and out of driveways at an angle or driving
over rough, uneven roads).
C
B
A
C
A
C
＊１２