Honda Accord 2008 Manual page 1329

07/11/02 09:20:41 61TA0000_170_0063
Power Steering
Steering Gearbox Installation (cont'd)
25. Install the rear engine mount (A) with new
mounting bolts, and lightly tighten them.
A/T
＊１５
10 x 1.25 mm
54 N·m (5.5 kgf·m, 40 lbf·ft)
Replace.
A
M/T
＊１６
12 x 1.25 mm
78 N·m
(8.0 kgf·m, 58 lbf·ft)
Replace.
26. Remove the engine support hanger, the hanger
balance bar, and the hanger adapter set.
27. Tighten the rear engine mount mounting bolts to
the specified torque.
17-62
10 x 1.25 mm
54 N·m
(5.5 kgf·m, 40 lbf·ft)
Replace.
12 x 1.25 mm
12 x 1.25 mm
78 N·m (8.0 kgf·m, 58 lbf·ft) 78 N·m
Replace. (8.0 kgf·m, 58 lbf·ft)
Replace.
A
28. Install the new damper fork mounting bolt (A) and
new mounting nut (B), and loosely tighten the nut.
B
12 x 1.25 mm
64 N·m
12 x 1.25 mm
(6.5 kgf·m, 47 lbf·ft)
78 N·m
Replace.
(8.0 kgf·m,
58 lbf·ft)
Replace.
29. Wipe off any grease contamination from the ball
joint tapered section and thread. Reconnect the tie-
rod ball joint (A) to the knuckle. Install the nut (B),
and tighten it to the specified torque.
A
B
12 x 1.25 mm
54 N·m
(5.5 kgf·m, 40 lbf·ft)
30. Install a new cotter pin (C) and bend it as shown.
31. Install exhaust pipe A (see page 9-8).
32. Install the splash shield (see page 20-272).
33. Lower the vehicle.
A
Replace.
C
Replace.
＊１７
＊１８