Honda Accord 2008 Manual page 1356

07/11/02 09:27:59 61TA0000_180_0023
Compliance Bushing Replacement
1. Remove the lower arm.
2. Mark alignment marks (A) on the bottom of the
lower arm next to the aligning marks (B) on the
compliance bushing.
NOTE: The compliance bushing has a specific
installation position. Turn the lower arm so that its
bottom side is up. Position the bushing identifying
mark (C) face up and near the tab (D) on the lower
arm. Then align the bushing aligning marks on the
bushing and the lower arm.
If the alignment marks are gone, align the angle (E)
between the lower arm and the bushing as shown.
Aligning the marking position
＊０４
Aligning the angle (reference)
＊０５
A B
A
C
D
FRONT
B
E
±
23 °15 ' 3 °
C
D
3. Press out the compliance bushing (A) with the
bushing driver, the bushing receiver set
(attachment A), and a hydraulic press, and remove
the bushing from the lower arm (B).
NOTE: Be careful not to damage the inside of the
bushing hole on the lower arm.
Press
A
070AF-TA0A100
B
070AF-TA0A220
(Attachment A)
(cont'd)
18-23
＊０６