Stabilizer Bar Replacement - Honda Accord 2008 Manual

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:27:59 61TA0000_180_0025

Stabilizer Bar Replacement

Special Tools Required

• Frame positioning guide pin 070AG-SJAA10S

• Engine hanger adapter VSB02C000015

• Front subframe adapter VSB02C000016

• Engine support hanger, A and Reds AAR-T1256

: Available through the Honda Tool and

Equipment Program, 888-424-6857.

1. Note these items during replacement:

• Be sure to remove the steering wheel before

disconnecting the steering joint. Damage to the

cable reel can occur.

• Lower the front subframe from the body, and

replace the front stabilizer bar through the gap

created by lowering the front subframe.

2. Do the battery terminal disconnection procedure

(see page 22-89).

3. Raise the vehicle, and support it with safety stands

in the proper locations (see page 1-9).

4. Remove the front wheels.

5. Remove the steering wheel (see page 17-24).

6. Remove the steering joint cover (A).

28 N·m (2.9 kgf·m, 21 lbf·ft)

28 N·m (2.9 kgf·m, 21 lbf·ft)

7. Loosen the steering joint upper bolt (B), and

remove the steering joint lower bolt (C), then

disconnect the steering joint from the pinion shaft.

• If the center guide is in place and has not moved,

leave it in place.

• If the center guide has moved or been removed,

8. Disconnect the power steering pressure (PSP)

switch connector (A).

ＴＡ０８ＡＥ４Ｂ２０２０００５６８５１ＫＢＡＴ００

Table of Contents