Honda Accord 2008 Manual page 1361

07/11/02 09:28:01 61TA0000_180_0028
Front Suspension
Stabilizer Bar Replacement (cont'd)
18. Attach the front subframe adapter (VSB02C000016)
to the subframe, hang the belt of the subframe
adapter over the front of the subframe, then secure
the belt with its stop.
＊１０
19. Raise the jack, line up the slots in the front
subframe adapter arms with the bolt holes on the
jack base, then securely attach them with four bolts.
20. Remove the front subframe mounting bolts (A) on
both sides of the middle mount.
NOTE: Use new mounting bolts during reassembly.
＊１１
A
10 x 1.25 mm
49 N·m (5.0 kgf·m, 36 lbf·ft)
Replace.
18-28
21. Disconnect both sides of the stabilizer link from the
22. Remove the flange bolts (A) on both sides of the
VSB02C000016
23. Loosen the front side of the front subframe
stabilizer bar (see page 18-24).
front subframe front bracket (B).
20 mm (13/16 in.)
A
12 x 1.25 mm
mounting bolts (C) until there is 20 mm (13/16 in.)
distance between the bolt seat and the mounting
surface. Do not loosen the mounting bolts more
than necessary.
B
C
14 x 1.5 mm
＊１２