Honda Accord 2008 Manual page 1000

07/11/02 08:49:05 61TA0000_140_0157
12. Turn the ignition switch to LOCK (0).
13. Jump the SCS line with the HDS.
14. Disconnect PCM connector B (49P).
15. Check for continuity between PCM connector
terminal B9 and the 3rd clutch transmission fluid
pressure switch connector terminal.
＊０２
PCM CONNECTOR B (49P)
OP3SW (BLU/WHT)
Terminal side of
female terminals
Is there continuity?
YES
NO −
connector terminal B9 and the 3rd clutch
transmission fluid pressure switch, then go to step
16.
16. Reconnect all connectors.
17. Turn the ignition switch to ON (II).
18. Clear the DTC with the HDS.
19. Start the engine, and warm it up to normal
operating temperature (the radiator fan comes on).
3RD CLUTCH
TRANSMISSION FLUID
PRESSURE
SWITCH CONNECTOR
Wire side of
female terminals
−
Go to step 23.
Repair open in the wire between PCM
20. Test-drive the vehicle in 3rd gear with the shift
lever in D for at least 2 seconds. Then drive in 4th
gear for at least 2 seconds.
21. Check for Temporary DTCs or DTCs with the HDS.
Is DT C P0848 indicated?
−
YES Check for poor connections or loose
terminals between the 3rd clutch transmission fluid
pressure switch and the PCM, then go to step 1.
NO − Go to step 22.
22. Monitor the OBD STATUS for P0848 in the DTCs
OP3SW MENU with the HDS.
(BLU/WHT)
Does the HDS indicate PASSED?
YES − Troubleshooting is complete. If any other
Temporary DTCs or DTCs were indicated in step 21,
go to the indicated DTC's troubleshooting.
NO − If the HDS indicates FAILED, check for poor
connections or loose terminals between the 3rd
clutch transmission fluid pressure switch and the
PCM, then go to step 1. If the HDS indicates NOT
COMPLETED, go to step 19.
23. Reconnect all connectors.
24. Update the PCM if it does not have the latest
software (see page 11-231), or substitute a known-
good PCM (see page 14-8).
25. Start the engine, and warm it up to normal
operating temperature (the radiator fan comes on).
26. Test-drive the vehicle in 3rd gear with the shift
lever in D for at least 2 seconds. Then drive in 4th
gear for at least 2 seconds.
(cont'd)
14-155