Honda Accord 2008 Manual page 1104

07/11/02 09:19:16 61TA0000_140_0261
21. Loosely tighten the subframe mounting bolt (A) in
the right rear stiffener; insert the subframe
positioning guide pin through the positioning slot
(B) on the right rear stiffener, through the
positioning hole (C) on the front subframe, and into
the positioning hole on the body, then tighten the
front subframe mounting bolt until the front
subframe insulator contacts the body.
＊１４
A
14 x 1.5 mm
103 N·m (10.5 kgf·m, 75.9 lbf·ft)
Replace.
22. Loosely tighten the front subframe mounting bolt
in the left rear stiffener in the same manner in step
20.
23. Reinsert the subframe positioning guide pin
through the positioning slot on the right rear
stiffener, through the positioning hole on the front
subframe, and into the positioning hole on the
body, then tighten the front subframe mounting
bolt to the specified torque.
24. Tighten the subframe mounting bolt in the left rear
stiffener in the same manner in step 22.
25. Tighten the right and left front subframe mounting
bolts to the specified torque.
C
12 x 1.25 mm
93 N·m
(9.5 kgf·m, 69 lbf·ft)
070AG-SJAA10S
Replace.
26. Check that the positioning holes and slots are
aligned using the subframe positioning guide pin.
27. Tighten the rear and front stiffener mounting bolts
to the specified torque.
28. Remove the jack and the front subframe adapter.
29. Tighten both of the front subframe mid-mount
mounting bolts.
30. Install the transmission lower mount nuts.
B
10 x 1.25 mm
44 N·m (4.5 kgf·m, 33 lbf·ft)
(cont'd)
14-259
＊１５