Honda Accord 2008 Manual page 1582

07/11/02 09:28:32 61TA0000_200_0015
8. Remove the door panel (A) with as little bending as
possible to avoid creasing or breaking it.
–1 Start at the bottom edge of the door panel,
–2 Detach the upper clips.
–3 Starting at the rear, pull the door panel upward.
＊０５
Fastener Locations
: Clip, 10
(Gray)
A
9. While holding the door panel (A) away from the
door, remove the inner handle (B) from the door
panel by releasing the hooks (C).
＊０６
release the clips with a commercially available
trim pad remover.
NOTE: The inner handle cable (B) and the latch
cable (C) are connected to the inner handle (D).
Do not pull the door panel up too far, or these
cables will be damaged.
B
C
C B
C
10. Remove the door panel (A) while pulling the inner
handle (B) out through the hole in the door panel.
11. Disconnect the inner handle cable (A) and the latch
cable (B) from the inner handle (C), then remove
the handle.
D
–1 Detach the inner handle cable fasteners (D, E),
then disconnect the inner handle cable from
the cable fasteners.
–2 Detach the latch cable fastener (F), and remove
the latch cable fastener (G) from the inner
handle by pinching its tabs out.
NOTE: Check if the cable fasteners are
damaged or stress-whitened.
D
F
B
A
B
A
E
G
20-13
＊０７
A
＊０８
C
(cont'd)