Honda Accord 2008 Manual page 1617

07/11/02 09:29:48 61TA0000_200_0050
Doors
Rear Door Outer Molding Replacement
Special Tools Required
KTC trim tool set SOJATP2014
Available through the American Honda Tool and
Equipment Program; call 888-424-6857
4-door
NOTE:
• If you remove the door outer molding, replace it with
a new one because it will bend during removal.
• Put on gloves to protect your hands.
• Take care not to scratch the door.
• Use the appropriate tool from the KTC trim tool set to
avoid damage when removing components.
1. Using a clip remover, detach the clips (A), then pull
back the door weatherstrip (B), and remove the
screws (C, D).
＊０１
Fastener Locations
A
20-48
: Clip, 3 C : Screw, 1 D
: Screw, 2
(Black)
C
A
B
B
A
D
A
D
2. While removing the upper edge of the door outer
molding (A) from the edge of the sash, cut the
double-sided adhesive tape (B) with a utility knife,
then remove the molding from the sash, and
remove the molding from between the door glass
outer weatherstrip (C) and the door.
B
A
3. Scrape off the remaining double-sided adhesive
tape from the sash, then clean the sash surface
with a sponge dampened in isopropyl alcohol.
4. Install the new door outer molding in the reverse
order of removal, and note these items:
• Insert the rear edge of the molding between the
door glass outer weatherstrip and the door
properly.
• Push the adhesive portions into place securely.
• Make sure the upper and lower sides of the
molding are catching the edges of the sash
properly.
• Push the door weatherstrip clips into place
securely.
B
ＴＡ０８ＡＢ４Ｊ１６１６６２２１２０１ＫＢＡＴ１５
A
C
＊０２