Transmission Fluid Inspection And Replacement; Back-Up Light Switch Test - Honda Accord 2008 Manual

07/11/02 09:23:53 61TA0000_130_0005
Transmission Fluid Inspection and
Replacement
1. Raise the vehicle on a lift.
2. Remove the oil filler plug (A) and sealing washer
(B), check the condition of the fluid, and make sure
it is at the proper level (C).
＊０１
A
3. If the fluid is dirty, remove the drain plug (A) and
the sealing washer (B), and drain the fluid.
＊０２
4. Install the drain plug with a new sealing washer,
and refill the transmission fluid to the proper level.
Fluid Capacity
1.9 L (2.0 US qt) at fluid change
2.0 L (2.1 US qt) at overhaul
Always use Honda Manual Transmission Fluid
(MTF).
5. Install the oil filler plug (C) with a new sealing
washer.
ＴＡ０８ＡＥＡＥ３４１０００４１７０１ＭＤＡＴ０１
B
C
B
Replace.

Back-up Light Switch Test

1. Disconnect the back-up light switch 2P connector
(A).
2. Check for continuity between the back-up light
switch 2P connector terminals No. 1 and No. 2.
There should be continuity only when the shift
lever is in reverse.
B
Replace.
C
44 N·m
(4.5 kgf·m,
33 lbf·ft)
A
3. If necessary, replace the back-up light switch.
39 N·m
Apply liquid gasket (P/N 08718-0001), and install it
(4.0 kgf·m,
29 lbf·ft)
on the transmission housing.
ＴＡ０８ＡＥＡＥ３４１０００１４００１ＦＥＡＴ０２
A
29 N·m
(3.0 kgf·m,
22 lbf·ft)
BACK-UP LIGHT SWITCH 2P CONNECTOR
Terminal side of male terminals
＊０１
＊０２
13-5 13-5