Honda Accord 2008 Manual page 1651

07/11/02 09:31:09 61TA0000_200_0084
Moonroof
Symptom Troubleshooting Index
Symptom
Water leaks from moonroof
Wind noise from moonroof
Motor noise from moonroof
Moonroof glass does not move,
but motor turns
Moonroof glass does not move
and motor does not turn (glass
can be moved with 4 mm
hexagonal wrench)
Moonroof glass does not stop at
proper flush closed position
Moonroof glass moves in a
jerking motion (moves 40 mm
(1.57 in.), stops for 0.4 seconds,
and repeats)
During auto close operation,
moonroof glass reverses when
no object is trapped
Moonroof glass moves, but
there is no AUTO function
20-82
ＴＡ０８ＡＢ９Ｊ３４２００００００００ＨＢＡＴ０１
Diagnostic procedure
1. Check for a clogged drain tube.
2. Check for a gap between the glass weatherstrip and the roof panel.
3. Check for a defective or an improperly installed glass weatherstrip or drain
channel.
4. Check for a gap between the drain seal and the roof panel.
5. Adjust the moonroof height.
1. Check for excessive clearance between the glass weatherstrip and the roof
panel.
2. Adjust the moonroof height.
1. Check for a loose motor.
2. Check for a worn gear or bearing.
3. Check for a deformed cable assembly.
4. Check for dirt or debris.
1. Check for foreign matter stuck between the guide rail and the slider.
2. Make sure the cable assembly is attached properly.
3. Check for a loose inner cable.
4. Check for a defective gear or inner cable.
1. Check for a run down battery.
2. Check for a blown fuse.
3. Check for a faulty moonroof switch.
4. Check for a defective motor control unit.
1. Reset the moonroof control unit (see page 22-350).
2. Check glass height adjustment.
Reset the moonroof control unit (see page 22-350).
1. Check for dirt and debris in the track.
2. Reset the moonroof control unit (see page 22-350).
Reset the moonroof control unit (see page 22-350).