Honda Accord 2008 Manual page 1085

07/11/02 09:18:39 61TA0000_140_0242
Automatic Transmission
ATF Temperature Sensor Test/Replacement (cont'd)
9. If the resistance is out of standard, replace the ATF
temperature sensor and the shift solenoid wire
harness; go to step 10. The ATF temperature sensor
is not available separately from the shift solenoid
wire harness. If the resistance is within the
standard, install the shift solenoid wire harness
with a new O-ring in the transmission housing,
then go to step 13.
10. Disconnect the connectors from the shift solenoid
valves, and replace the ATF temperature sensor
and the shift solenoid wire harness.
＊０４
F
G
11. Install a new O-ring (F) on a new shift solenoid wire
harness (G), and install the shift solenoid wire
harness in the transmission housing.
12. Connect the shift solenoid wire harness terminals
to shift solenoid valves:
• BLU wire connector to shift solenoid valve A.
• ORN wire connector to shift solenoid valve B.
• GRN wire connector to shift solenoid valve C.
• YEL, WHT, and WHT wire connector to shift
solenoid valve D.
• RED wire connector to shift solenoid valve E.
13. Install a new gasket, the dowel pins, and the shift
solenoid valve cover.
14. Check the connector for rust, dirt, or oil, clean or
repair as needed, then connect the connector
securely.
14-240
15. Refill the transmission with ATF (see step 4 on page
14-242).
16. Install the splash shield.
17. Install the left front wheel.
C
E
B
D
A
6 x 1.0 mm
12 N·m
(1.2 kgf·m, 8.7 lbf·ft)