Honda Accord 2008 Manual page 1034

07/11/02 09:16:45 61TA0000_140_0191
14. Inspect shift solenoid valve D and the shift solenoid
harness (see page 14-222).
15. Replace either shift solenoid valve D or the shift
solenoid harness (see page 14-226), whichever
failed the test, then go to step 16.
16. Reconnect all connectors.
17. Turn the ignition switch to ON (II).
18. Clear the DTC with the HDS.
19. Start the engine, and wait for at least 1 second.
Test-drive the vehicle in 2nd gear with the shift
lever in D for at least 1 second.
20. Check for Temporary DTCs or DTCs with the HDS.
Is DT C P0982 indicated?
−
YES Check for intermittent short to body ground
in the wire between shift solenoid valve D and the
PCM, then go to step 1.
NO − Go to step 21.
21. Monitor the OBD STATUS for P0982 in the DTCs
MENU with the HDS.
Does the HDS indicate PASSED?
−
YES Troubleshooting is complete. If any other
Temporary DTCs or DTCs were indicated in step 20,
go to the indicated DTC's troubleshooting.
NO − If the HDS indicates FAILED, check for
intermittent short to body ground in the wire
between shift solenoid valve D and the PCM, then
go to step 1. If the HDS indicates NOT COMPLETED,
go to step 19.
22. Reconnect all connectors.
23. Update the PCM if it does not have the latest
software (see page 11-231), or substitute a known-
good PCM (see page 14-8).
24. Start the engine, and wait for at least 1 second.
Test-drive the vehicle in 2nd gear with the shift
lever in D for at least 1 second.
25. Check for Temporary DTCs or DTCs with the HDS.
Is DT C P0982 indicated?
−
YES Check for intermittent short to body ground
in the wire between shift solenoid valve D and the
PCM. If the PCM was updated, substitute a known-
good PCM (see page 14-8), then go to step 24. If the
PCM was substituted, go to step 1.
−
NO Go to step 26.
26. Monitor the OBD STATUS for P0982 in the DTCs
MENU with the HDS.
Does the HDS indicate PASSED?
−
YES If the PCM was updated, troubleshooting is
complete. If the PCM was substituted, replace the
original PCM (see page 11-232). If any other
Temporary DTCs or DTCs were indicated in step 25,
go to the indicated DTC's troubleshooting.
−
NO If the HDS indicates FAILED, check for
intermittent short to body ground in the wire
between shift solenoid valve D and the PCM. If the
PCM was updated, substitute a known-good PCM
(see page 14-8), then go to step 24. If the PCM was
substituted, go to step 1. If the HDS indicates NOT
COMPLETED, go to step 24.
14-189