Honda Accord 2008 Manual page 1313

07/11/02 09:20:19 61TA0000_170_0047
Power Steering
Steering Gearbox Overhaul (cont'd)
12. Remove the cylinder line A and B from the steering
gearbox.
＊０９
13. Drain the fluid from the cylinder fittings by slowly
moving the steering rack back and forth.
14. Remove the two flange bolts, then remove the
valve body unit (A) from the gearbox housing (B).
Remove the O-ring (C).
＊１０
17-46
A
B
A
C
Replace.
B
15. Apply vinyl tape to the end of the steering rack and
the gearbox housing. Drill a 3.0 4.0 mm (0.12
0.16 in.) diameter hole about 2.5 3.0 mm (0.10
0.12 in.) in depth in the staked point (A) on the
cylinder. Do not allow metal shavings to enter the
cylinder side on the gearbox housing. After
removing the cylinder end (B), remove any burrs at
the staked point.
A
16. Hold the gearbox housing using a C-clamp (A) and
wooden blocks (B) as shown. Do not clamp the
cylinder part of the gearbox housing in the vise.
Remove the vinyl tape. Then remove the cylinder
end (C).
C
− −
− −
B
A
B
＊１１
＊１２