07/11/02 09:25:06 61TA0000_130_0042
Manual Transmission
Mainshaft Reassembly (cont'd)
14. Install the synchro spring (A).
*10
15. Install the synchro ring (B) by aligning the synchro
ring fingers (C) with the grooves in the 5th synchro
hub (D). Then install the MBS distance collar and
tapered cone ring.
16. Install the new ball bearing (A) using the 40 mm I.D.
driver (B), 30 mm I.D. attachment (C), and a press
(D).
*11
C
07746-0030300
13-42
13-42
B
A
C
D
D
B
07746-0030100
A
Countershaft Assembly Clearance
Inspection
1. Measure the clearance between 1st gear (A) and
the distance collar (B) with a feeler gauge (C). If the
clearance is more than the service limit, go to
step 2.
Standard:
0.06 0.16 mm (0.002 0.006 in.)
−
Service Limit: 0.25 mm (0.010 in.)
C
B
2. Measure the length of the distance collar as shown.
• If the length is not within the standard, replace
the distance collar.
• If the length is within the standard, go to step 3.
Standard: 23.03 23.08 mm (0.907 0.909 in.)
−
TA08AEAE34150200000MAAT10
−
A
−
*01
*02