Brake Pedal And Brake Pedal Position Switch Adjustment - Honda Accord 2008 Manual

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:31:43 61TA0000_190_0006

Conventional Brake Components

Brake Pedal and Brake Pedal Position Switch Adjustment

Pedal Height

1. Turn the brake pedal position switch (A)

counterclockwise, and pull it back until it is no

longer touching the brake pedal.

2. Remove the footrest (see step 4 on page 20-140),

then remove the steering joint cover (see page

3. Pull back the carpet and find the cutout (B) in the

insulation. Measure the pedal height (C) at the

center of the pedal pad (D) to the floor without the

Standard pedal height (with carpet removed):

M/T model: 156 mm (6 1/8 in.)

A/T model: 160 mm (6 5/16 in.)

4. Loosen the pushrod locknut (A), and screw the

pushrod (B) in or out with pliers until the standard

pedal height from the floor is reached. After

adjustment, tighten the locknut firmly. Do not

adjust the pedal height with the pushrod pressed.

(1.5kgf·m, 11 lbf·ft)

Brake Pedal Position Switch Clearance

5. Lift up on the brake pedal by hand. Push in the

brake pedal position switch until its plunger is fully

pressed (threaded end (A) touching the pad (B) on

the pedal arm). Turn the switch 45 ° clockwise to

lock it. The gap between the brake pedal position

switch and the pad is automatically adjusted to

0.7 mm (0.028 in.) by locking the switch. Make sure

the brake lights go off when the pedal is released.

6. Install the all removed parts in the reverse order of

7. Check the brake pedal free play.

ＴＡ０８ＡＥ４Ｄ１４３０００１４８０１ＭＢＡＴ１０

0.7 mm (0.028 in)

Table of Contents