Honda Accord 2008 Manual page 832

07/11/02 09:25:16 61TA0000_130_0059
10. Install the three 14 x 20 mm dowel pins (A).
＊０９
D
34 N·m
(3.5 kgf·m,
25 lbf·ft)
A
11. Set the tapered cone ring (B) as shown. Place the
transmission housing on the clutch housing, being
careful to line up the shafts.
12. While expanding the 72 mm snap ring (C) of the
countershaft ball bearing using the snap ring pliers,
push the transmission housing down to start the
countershaft ball bearing through the snap ring.
Then release the pliers, and push down the housing
until it bottoms and the snap ring snaps in place in
the countershaft ball bearing snap ring groove.
13. Make sure the 72 mm snap ring is securely seated
in the groove of the countershaft bearing.
Dimension
＊１０
−
as installed: 3.3 6.0 mm
(0.13 0.24 in.) −
14. Apply liquid gasket (P/N 08718-0001) to the threads
of the 32 mm sealing cap (D), and install it on the
transmission housing.
15. Install transmission hangers A and B, and the 8 mm
flange bolts, finger-tight.
C
B
B
16. Tighten the 8 mm flange bolts in a crisscross
pattern in several steps.
Specified Torque: 8 x 1.25 mm
A
27 N·m (2.8 kgf·m, 20 Ibf·ft)
(cont'd)
13-59
＊１１
＊１２