Honda Accord 2008 Manual page 1225

07/11/02 09:24:03 61TA0000_140_0382
Transmission Housing
Shaft Assembly and Housing Installation (cont'd)
19. Install a new O-ring (A) on the input shaft
(mainshaft) speed sensor (B), and install the input
shaft (mainshaft) speed sensor in the transmission
housing.
＊０９
6 x 1.0 mm
12 N·m
(1.2 kgf·m,
8.7 lbf·ft)
C
D
6 x 1.0 mm
12 N·m (1.2 kgf·m, 8.7 lbf·ft)
20. Install a new O-ring (C) on the output shaft
(countershaft) speed sensor (D), and install the
output shaft (countershaft) speed sensor and the
sensor washer (E).
21. Install the shift solenoid wire harness (F) in the
transmission housing with a new O-ring (G).
＊１０
A
B
C
14-380
A
B
E
RED BLU
ORN
D
GRN
E
22. Connect the shift solenoid wire harness connectors
to the shift solenoid valves:
• BLU wire connector to shift solenoid valve A.
• ORN wire connector to shift solenoid valve B.
• GRN wire connector to shift solenoid valve C.
• YEL, WHT, and WHT wire connector to shift
solenoid valve D.
• RED wire connector to shift solenoid valve E.
23. Install the shift solenoid valve cover (A) with the
two dowel pins (B) and a new gasket (C).
YEL,
WHT, WHT
6 x 1.0 mm
12 N·m
(1.2 kgf·m,
8.7 lbf·ft)
F
G
6 x 1.0 mm
12 N·m
(1.2 kgf·m,
8.7 lbf·ft)
A
B
C
B
＊１１