Honda Accord 2008 Manual page 1437

07/11/02 09:31:47 61TA0000_190_0016
Conventional Brake Components
Front Brake Pad Inspection and Replacement (cont'd)
Inspection - AKEBONO Type
1. Raise the front of the vehicle, and support it with
safety stands in the proper locations (see page 1-9).
2. Remove the front wheels.
3. Check the thickness (A) of the inner pad (B) and the
outer pad (C). Do not include the thickness of the
backing plate.
Brake pad thickness:
Standard:
Service limit: 1.6 mm (0.06 in.)
Inner pad
＊１０
Outer pad
＊１１
19-16
10.5 10.8 mm (0.41 0.43 in.) −
A
B
B
A
4. If the brake pad thickness is of any of the pads less
than the service limit, replace the front brake pads
as a set.
5. Clean the mating surfaces of the brake disc and the
inside of the wheel, then install the front wheels.
−