Honda Accord 2008 Manual page 1304

07/11/02 09:19:47 61TA0000_170_0038
8. Apply vinyl tape to the splines on the pinion shaft.
9. Remove the strut brace (if equipped) (see page
20-287).
10. Remove the P/S heat shield (A).
＊０４
A
11. Remove the hood support rod, then use it as shown
to prop the hood in the wide-open position.
＊２７
12. Remove the front grille cover (see page 20-255).
13. Attach the engine hanger adapter (VSB02C000015)
to the threaded hole in the cylinder head.
6 x 1.0 mm
14. Install the engine support hanger (AAR-T1256),
then attach the hook to the slotted hole in the
hanger adapter. Tighten the wing nut (A) by hand to
lift and support the engine/transmission.
NOTE: Be careful when working around the
windshield.
VSB02C000015
VSB02C000015
AAR-T1256
(cont'd)
17-37
＊０５
＊０６