Honda Accord 2008 Manual page 1671

07/11/02 09:32:25 61TA0000_200_0104
Interior Trim
Trim Removal/Installation - Pillar Areas (cont'd)
1. Pull the door opening seal away from the A-pillar
as needed:
• 2-door (see step 6 on page 20-98)
• 4-door (see step 6 on page 20-100)
2. Hit the upper clip in the A-pillar trim (A) with a
rubber mallet. The clip is located under the point
where the triangle mark (B) on the edge of the trim
indicates. Hitting the clip slides the projections (C)
on the pin (D) and pushes it into the grommet (E)
and against the body (F).
NOTE: The grommet must be replaced with a new
one when the A-pillar trim is reinstalled.
＊０２
B
20-102
F
E
D
C
3. Pull the top of the A-pillar trim (A) back by hand to
remove the upper clip (B) from the body (C).
A
A
C
B
A
C
B
＊０３
A