Driveshaft Installation - Honda Accord 2008 Manual

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:17:17 61TA0000_160_0019

Driveshaft Installation

NOTE: Before starting installation, make sure the

mating surfaces of the joint and the splined section are

1. Apply about 5 g (0.18 oz) moly 60 paste

(P/N 08734-0001) to the contact area (A) of the

outboard joint and the front wheel bearing.

NOTE: The paste helps to prevent noise and

(P/N 08734-0001)

2. Install a new set ring (A) onto the set ring groove

(B) of the driveshaft.

3. Apply 0.5 1.0 g (0.02 0.04 oz) of super high temp

urea grease (P/N 08798-9002) to the whole splined

surface (A) of the right driveshaft. After applying

grease, remove the grease from the splined

grooves at intervals of 2 3 splines and from the

set ring groove (B) so that air can bleed from the

intermediate shaft.

(P/N 08798-9002)

4. Clean the areas where the driveshaft contacts the

differential thoroughly with solvent or brake

cleaner, and dry with compressed air.

NOTE: Do not wash the rubber parts with solvent.

5. Insert the inboard end (A) of the driveshaft into the

differential (B) or intermediate shaft (C) until the set

ring (D) locks in the groove (E).

NOTE: Insert the driveshaft horizontally to prevent

damaging the differential oil seal.

ＴＡ０８ＡＥ４Ｅ１６２２６６０００００ＫＣＡＴ００

Table of Contents