Honda Accord 2008 Manual page 1496

07/11/02 09:34:58 61TA0000_190_0075
DTC 12-21: Right-front Wheel Speed Sensor
Installation Error
DTC 14-21: Left-front Wheel Speed Sensor
Installation Error
DTC 16-21: Right-rear Wheel Speed Sensor
Installation Error
DTC 18-21: Left-rear Wheel Speed Sensor
Installation Error
1. Test-drive the vehicle. Drive the vehicle at 7 mph
(10 km/h) or more.
NOTE: Drive the vehicle on a straight section of
road, not on a lift.
2. Check the RF, LF, RR, LR WHEEL SPD in the VSA
DATA LIST with the HDS.
Are all f our values the same?
YES − Intermittent failure, the system is OK at this
time. Check for loose terminals between the wheel
speed sensor 2P connector and the VSA modulator-
control unit 36P connector. Refer to intermittent
failures troubleshooting (see page 19-47).
NO − Go to step 3.
3. Turn the ignition switch to LOCK (0).
4. Check that the appropriate wheel speed sensor is
properly mounted (see page 19-144).
DTC
12-21
14-21
16-21
18-21
Is the wheel speed sensor installation OK ?
−
YES Replace the appropriate wheel speed sensor
(see page 19-144).
NO − Reinstall the wheel speed sensor, and check
the mounting position (see page 19-144).
ＴＡ０８ＡＥ４Ｋ８０１０００Ｒ１２２１ＦＡＡＴ００
Appropriate Wheel Speed Sensor
Right-front
Left-front
Right-rear
Left-rear
DTC 12-22: Right-front Wheel Speed Sensor
Installation Error (19 mph (30 km/h) or More)
DTC 14-22: Left-front Wheel Speed Sensor
Installation Error (19 mph (30 km/h) or More)
DTC 16-22: Right-rear Wheel Speed Sensor
Installation Error (19 mph (30 km/h) or More)
DTC 18-22: Left-rear Wheel Speed Sensor
Installation Error (19 mph (30 km/h) or More)
1. Test-drive the vehicle. Drive the vehicle between
19 mph (30 km/h) and 31 mph (50 km/h) for
70 seconds or more.
NOTE: Drive the vehicle on a straight section of
road, not on a lift.
2. Check the RF, LF, RR, LR WHEEL SPD in the VSA
DATA LIST with the HDS.
Are all f our values the same?
YES − Intermittent failure, the system is OK at this
time. Check for loose terminals between the wheel
speed sensor 2P connector and the VSA modulator-
control unit 36P connector. Refer to intermittent
failures troubleshooting (see page 19-47).
NO − Go to step 3.
3. Turn the ignition switch to LOCK (0).
4. Check that the appropriate wheel speed sensor is
properly mounted (see page 19-144).
DTC Appropriate Wheel Speed Sensor
12-22 Right-front
14-22 Left-front
16-22 Right-rear
18-22
Is the wheel speed sensor installation OK ?
−
YES Replace the appropriate wheel speed sensor
(see page 19-144).
NO − Reinstall the wheel speed sensor, and check
the mounting position (see page 19-144).
ＴＡ０８ＡＥ４Ｋ８０１０００Ｒ１２２２ＦＡＡＴ０２
Left-rear
19-75 19-75