Mainshaft Assembly Clearance Inspection - Honda Accord 2008 Manual

07/11/02 09:24:37 61TA0000_130_0034
Manual Transmission

Mainshaft Assembly Clearance Inspection

NOTE: If replacement is required, always replace the
synchro sleeve and synchro hub as a set.
1. Support the bearing inner race with an appropriate
sized socket (A), and push down on the mainshaft
(B).
Standard:
Service Limit: 0.25 mm (0.010 in.)
＊０１
2. Measure the clearance between 2nd gear (C) and
3rd gear (D) with a feeler gauge (E).
• If the clearance is more than the service limit, go
to step 3.
• If the clearance is within the service limit, go to
step 4.
3. Measure the thickness of 3rd gear.
• If the thickness is less than the service limit,
replace 3rd gear.
• If the thickness is within the service limit, replace
the 3rd/4th synchro hub and 3rd/4th synchro
sleeve as a set.
Standard:
Service Limit: 23.80 mm (0.937 in.)
＊０２
13-34
0.06 0.16 mm (0.002 0.006 in.) − −
B
E
A
−
23.92 23.97 mm (0.941 0.944 in.)
4. Measure the clearance between 4th gear (A) and
the distance collar (B) with a dial indicator (C). If the
clearance is more than the service limit, go to
step 5.
Standard:
Service Limit: 0.25 mm (0.010 in.)
C
C
D
5. Measure the length
shown.
• If the length
the distance collar.
• If the length
step 6.
Standard: 24.03 24.08 mm (0.946 0.947 in.)
−
ＴＡ０８ＡＥＡＥ３４１５０４０００００ＭＡＡＴ００
0.06 0.16 mm (0.002 0.006 in.) − −
A
B B
of the distance collar as
is not within the standard, replace
is within the standard, go to
− −
＊０３
＊０４