Honda Accord 2008 Manual page 854

07/11/02 08:45:51 61TA0000_140_0011
11. Install a known-good PCM in the reverse order of
removal.
12. Do the battery installation procedure (see page
22-90).
NOTE: While doing the battery installation
procedure, do not start the engine.
13. Turn the ignition switch to ON (II).
NOTE: DTC P0630 ''VIN Not Programmed or
Mismatch'' may be stored because the VIN has not
been programmed into the PCM; ignore it, and
continue this procedure.
14. Manually input the VIN to the PCM with the HDS.
15. Update the PCM if it does not have the latest
software.
16. Select the IMMOBI SYSTEM with the HDS.
17. Enter the immobilizer code using the PCM
replacement procedure in the HDS; this allows you
to start the engine.
18. Reset the PCM with the HDS.
19. If the TP POSITION CHECK failed in step 5, clean
the throttle body (see page 11-385).
20. Do the PCM idle learn procedure (see page 11-343).
21. Do the CKP pattern learn procedure (see page 11-5).
Failure Reproduction Technique
Be careful to the following points while the vehicle is
raising on a lift for the test-drive.
• Disable the VSA by pressing the VSA OFF switch.
• VSA DTC's may come on when test-driving on a lift. If
the VSA DTC(s) come on, clear the DTC(s) with the
HDS.
14-9