Stabilizer Link Removal/Installation - Honda Accord 2008 Manual

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:28:43 61TA0000_180_0047

Stabilizer Link Removal/Installation

1. Raise the rear of the vehicle, and support it with

safety stands in the proper locations (see page 1-9).

2. Remove the rear wheel.

3. Remove the self-locking nuts (A) while holding the

respective joint pin (B) with a hex wrench (C), then

remove the stabilizer link (D).

4. Install the stabilizer link on the stabilizer bar (E) and

knuckle adding in the brake hose bracket (F) with

the joint pins set at the center of their range of

• The stabilizer link has a paint mark (G). The paint

mark indicates the difference between the left

and right stabilizer links.

• Install the end of the stabilizer link with the paint

mark in the upper position.

5. Install the new self-locking nuts, and tighten them

to the specified torque values while holding the

respective joint pin with a hex wrench.

10 x 1.25 mm

44 N·m (4.5 kgf·m, 33 lbf·ft)

10 x 1.25 mm

38 N·m (3.9 kgf·m, 28 lbf·ft)

6. Clean the mating surfaces of the brake disc and the

inside of the wheel, then install the rear wheel.

7. Test-drive the vehicle.

8. After 5 minutes of driving, tighten the self-locking

nuts again to the specified torque values.

ＴＡ０８Ａ００Ｂ４４１０００５６８６１ＫＤＡＴ００

Table of Contents