Honda Accord 2008 Manual page 1632

07/11/02 09:30:21 61TA0000_200_0065
13. Attach the rubber dam B with adhesive tape to the
inside surface of the windshield (A) as shown.
• Be sure the rubber dam lines up with the
alignment marks (C).
• With the edge (D) of the black ceramic on the
windshield as a guide, attach the rubber dam B to
the windshield.
• Be careful not to touch the windshield where
adhesive will be applied.
Rubber dam adhesive tape:
Thickness 0.16 mm (0.006 in.)
Width 3.5 mm (0.14 in.)
＊０５
A
B
D
54 mm
(2.1 in.)
A
B
C
14. Attach the molding (A) with adhesive tape (B) to the
upper edge of the windshield (C). Be careful not to
touch the windshield where adhesive will be
applied.
Molding adhesive tape:
Thickness 0.8 mm (0.03 in.)
Width 4 mm (0.16 in.)
2-door
5.5 mm
(0.22 in.)
A
4-door
7 mm
(0.28 in.)
A
A
C
B
C
A
C
A
C
B
C
A
C
(cont'd)
20-63
＊０６
＊０７