Transmission Range Switch Test - Honda Accord 2008 Manual

07/11/02 09:20:00 61TA0000_140_0291

Transmission Range Switch Test

1. Raise the vehicle on a lift, or apply the parking
brake, block the rear wheels, and raise the front of
the vehicle. Make sure it is securely supported.
2. Disconnect the transmission range switch
connector (A), then remove the connector from the
connector bracket (B).
＊０１
3. Remove the transmission range switch harness
clamps (C) from the clamp bracket (D).
4. Check for continuity between the terminals at the
harness connector. There should be continuity
between the terminals in the following table for
each switch position.
Transmission Range Switch Harness Connector
＊０２
Position/Connector Terminal/Signal Connections
P
R
N
D
D3
2
1
B
D
C
3 6
1 2 4 5 7
ATP ATP ATP
GND D P
R
2-1 FWD NP
5. Transmission range switch test is completed if the
test results are OK.
If there is no continuity between any terminals, go
to step 6.
6. Remove the transmission range switch cover.
A
8 9 10
ATP
D3 N
RVS
ＴＡ０８ＡＥＢＥ１０４１０７５９８１１ＦＥＡＴ００
＊０３
6 x 1.0 mm
12 N·m
(1.2 kgf·m,
8.7 lbf·ft)
(cont'd)
14-289